GAMECUBE XENO CHIP INSTALL

Some of the points have more than one place they can be soldered to on the circuit board. Here are the points you will need to solder the wires to. The yellow circle is around the place we will be installing the modchip. Here are the two locations we are concerned with. You will need six of them, preferably about 2' long each and in different colors to avoid confusion. A good place to look for them is inside the cables of a broken gaming controller. For doing a wired install, you will need some very thin flexible wires.

GAMECUBE XENO CHIP INSTALL

However, it is strongly recommended that you use wires to install it instead, since they are significantly easier to troubleshoot, and the modchip is much easier to remove or replace. The modchip is made so that it can be directly soldered onto the circuit board. Remove these screws as well, and then you'll have access to the daughterboard underneath. The fan will need to be removed in order to reach the four underneath it (When putting it back together, make sure to put those in before the fan.)ДЄfter taking out all of those screws, you can remove the silver plate with the laser assembly still attached. Remove the screws from all the places circled in blue. This picture is after the laser assembly has been removed so that all screwholes can be seen at once. After you remove those four bolts, you can take off the top half of the Gamecube. The proper bit costs $3 shipped, and if you get melted plastic on the bolts, you won't be able to get into your Gamecube. Some guides say you can melt a pen and use that to form the bit and remove the screw, but this is not recommended. To disassemble your Gamecube, first you will need to remove the four hexbolts on the bottom side of it using your 4.5mm security bit. That way you can see where everything went exactly when putting it back together. **If this is your first time disassembling a Gamecube, it is a good idea to take pictures with your phone as you go. You will need access to the bottom side of the daughterboard for this project. Xeno GC / XenoGC modchip (~$3 on Ebay including shipping)Д¤.5mm Security Bit (~$3 on Ebay including shipping)Д«endy Small Wires (can be found in broken controller cables)Д«urned games for testing (preferably Ritek Ridata mini dvds) There are six points that must be soldered in order for this to work, and the leds built into the chip will tell you when it's working. It is designed to sit directly on the underside of the daughterboard for the disc drive. This modchip is a tiny chip designed to go inside a Gamecube console to allow it to read burned copies of games. Hopefully this guide will clear some of that up. There is a lot of information out there about these Gamecube modchips, but a lot of it is incorrect.

Gamecube xeno chip